• Double click on My Computer.

• Double click on Control Panel icon.

• Double click on Dial-Up Networking. You may need to Click on "view all control panel options".

• Double click on Make New Connection.

• In the field Type a name for the computer you are dialing, type Everest and click the Configure button.

• Now you will be asked for a phone number to dial in to. Leave the area code blank, and input the local access number for your area.

• Click Finish.

• Right Click once on the Everest Access icon.
• Left Click once on Properties.

• You will see the dial in phone number and below that a box that says Use area code and Dialing Properties, remove the check from this box. Click on the Networking tab.

• Make sure that the following are checked. Server assigned IP address, Server assigned name server addresses, Use IP header compression, and Use default gateway on remote Network.
• Make sure only Enable software compression at the top is checked, and TCP/IP at the bottom is checked. Click on the TCP/IP Settings button.

• Click on Create a Shortcut, you will get a window that says you cannot create a shortcut here, do you want to put this on your desktop? Click Yes. Close the Dial-Up Networking window.

Your computer is ready to connect to the Internet!